Cissell DX4 CONTROLLER Bedienungsanleitung PDF herunterladen (Seite 4)

Error Codes

Page 4 of 18 FB08-15

Control Type: Micro 20

NOTE: When a malfunction occurs during a program, the central display will communicate the appropriate

error message at the end of the cycle. When the malfunction has been corrected and a new program selected,

the error message will disappear. When error codes E6, E7, E9 or Eb are detected at the start of a cycle, the

program will not start and the error message will remain on display until the problem is corrected.

Error Code Probable Cause Possible Corrective Actions

E3 (OPL Models) The E Prom is defective

•

Replace the E Prom

E3 and a program number (Coin

Models)

This indicates an incorrect price

adjustment for the program (i.e.

a coin value of “0” or larger than

“1000” was programmed).

•

Correct coin value adjustment

E4 (water level) Water level was not reached

after 15 minutes.

•

Check inlet water supply

• Inspect inlet water valves

• Inspect drain valve

• Check water level switch

E5 (heating) Programmed temperature was

not reached after 80 minutes.

• Check auxcillary heating

system

• Inspect temperature sensor

• Check water safety level

switch

E6 (door lock) The door lock was released

during the wash cycle.

• Check door lock circuit

• Inspect door lock mechanism

E7 (safety level) The water did not drain and

machine did not spin.

• Inspect drain valve

• Check drain outlet

E8 (temperature sensor) The sensor or temperature

sensor curcuit is defective.

• Replace temperature sensor

• Repair wiring circuit

E9 (motor protection) The thermo-magnetic protection

was activated five times or high

motor current was detected.

• Check the following:

a. motor

b. motor connections

c. contactors

d. input voltage

e. inverter

f. motor and machine

bearings

g. excessive high foam in

cylinder after rinsing

1 2 3 4 5 6 7 8 9 ... 17 18

Kommentare zu diesen Handbüchern

Keine Kommentare

Cissell DX4 CONTROLLER Bedienungsanleitung Seite 4

Kommentare zu diesen Handbüchern